Gallagher Wireless Pump Controller 12V | Battery Powered | Series 1

What Farmco Recommends It For:

We recommend the Gallagher Wireless Pump Controller for farmers running an original Gallagher Series 1 Wireless Water Monitoring System. It’s ideal for replacing a damaged controller or adding pump automation to remote bores, solar pumps and off-grid diesel or gas pump stations. It runs off a 12V battery, so you can install it where you don’t have mains power.

Why It’s a Farmco Favourite:

It keeps your existing Series 1 setup working without the cost of upgrading to a whole new system. The controller starts and stops your pump automatically based on tank levels, so you spend less time and fuel on water runs. Its built-in run-time limit also protects your pump and water if something goes wrong in the paddock.

Automate Your Water Supply

The G98313 reads the tank-level signals from your Gallagher transmitter and switches your pump on or off to hold your chosen water levels. Set it to Automatic mode and let it do the work, or switch to Manual mode and use the Start and Stop buttons on the front panel.

Built-In Protection

A burst pipe or a leaking trough can leave a pump running for hours. This controller lets you set a maximum run time of up to 24 hours. If the pump goes past that limit, the controller shuts it down automatically to prevent pump burnout and water loss.

Know What Your Pump Is Doing

The controller sends live pump status (On, Off, Standby or Fault) back to your Gallagher Touchscreen Display. You can see straight away whether your pump is running properly without driving out to check.

Made for Australian Conditions

The rugged, UV-stabilised, marine-grade casing stands up to harsh sun, dust and weather. The standard antenna gives you up to 4km of line-of-sight range, and you can reach 10–15km with Gallagher directional long-range antennas.

Product Support

For product support, setup help or technical questions, please contact Gallagher Animal Management Australia directly. Their team can help you get the most from your Gallagher system. Call them on 1800 425 524.

Please note: This is a discontinued legacy module. It works only with original Gallagher Series 1 Touchscreen Receivers and isn’t compatible with Series 2 systems.

Automatic pump control: Starts and stops your pump based on tank levels sent from your Gallagher transmitter
Auto and Manual modes: Switch modes easily, with Start and Stop buttons for manual control
Run-time fail-safe: Adjustable maximum run time of up to 24 hours, with automatic emergency shutdown
Live status reporting: Sends On, Off, Standby and Fault status to your Touchscreen Display
12V DC battery powered: Suits off-grid bores, solar pumps and remote pump stations
Wireless range: Up to 4km line of sight with the standard antenna, or 10–15km with long-range antennas
Rugged housing: UV-stabilised, marine-grade casing with a mounting tab for secure installation
Easy connection: Front-panel Connect button for pairing with your system

Brand: Gallagher
Model number: G98313
Product status: Discontinued / legacy replacement module
Compatibility: Original Gallagher Series 1 Wireless Water Level Monitoring Touchscreen Receivers (desktop or wall-mount). Not compatible with Series 2 systems
System capacity: Part of a system that supports up to 9 tank units
Power: 12V DC battery, such as a deep-cycle battery setup
Relay operation: Connects into standard low-voltage pump pilot or starter control circuits
Usage: Mount with a clear line of sight to the receiver for the best range
Storage: Store in a dry, cool place out of direct sunlight when not installed
Safety: Have a licensed electrician do any pump starter or electrical connections, and follow Gallagher’s wiring instructions